PRE-RELEASE
Checking bearing clearances
| Checking bearing clearances |
| 1. |
CAUTION: When measuring bearing clearance using Plastigauge, make sure that none gets into the oil holes. Turn the engine upside down on the stand so that the weight of the crankshaft does not affect the measurements.
|
|
| 2. |
Clean the parts to be measured so that they are dry and free from oil and dirt. Place a strip of Plastigauge along the shaft.
|
|
| 3. |
Fit the bearing cap.
Tightening torque 90 Nm + 60° (66 lbf ft + 60°) The crankshaft must remain absolutely still while measurement is in progress. |
|
| 4. |
Remove the bearing cap. The strip of Plastigauge should now have adhered to either the bearing cap or the main journal.
|
|
| 5. |
Measure the width of the Plastigauge strip using the scale printed on the package and read off the clearance. One side of the packaging is calibrated in mm and the other side in thousandths of an inch. Measure the strip at its widest point, taking care not to touch it with your fingers.
See
Camshaft
for the correct dimensions.
|
|
| Big-end bearing |
Measure the clearance with 30 06 558 Plastigauge which is available in three thicknesses. Use type PG-1 (green).
| 1. |
CAUTION: When measuring bearing clearance using Plastigauge, make sure that none gets into the oil holes. Clean the parts that are to be measured, making sure that they are dry and free from oil and dirt. Place a strip of Plastigauge lengthwise along the shaft.
|
|
| 2. |
Fit the bearing cap.
Tightening torque 35 Nm + 45° (26 lbf ft + 45°) The crankshaft must remain absolutely still while measurement is in progress. |
|
| 3. |
Remove the bearing cap. The strip should now have adhered to either the bearing cap or the crankshaft journal.
|
|
| 4. |
Measure the width of the Plastigauge strip using the scale printed on the package and read off the clearance. One side of the packaging is calibrated in mm and the other side in thousandths of an inch. Measure the strip at its widest point, taking care not to touch it with your fingers.
See
Camshaft
for the correct dimensions.
|
|
