Changing engine oil and oil filter
|
|
Changing engine oil and oil filter
|
|
1.
|
Remove the upper engine cover.
|
|
2.
|
Carefully press down the catches with a screwdriver and unplug the connector for the atmospheric pressure sensor and manifold absolute pressure sensor. Move aside the cables.
|
|
4.
|
Raise the car and place a receptacle underneath.
|
|
5.
|
Remove the drain plug and drain the engine oil.
|
|
6.
|
Fit the oil plug with a new O-ring.
Tightening torque 25 Nm (18 lbf ft).
|
|
7.
|
Lower the car, remove the cover and the filter element as well as the O-ring from the cover. Collect any spilled oil with a rag.
|
|
8.
|
Fit a new filter element and O-ring to the cover, lubricate the O-ring with engine oil.
|
|
9.
|
Fit the filter cover.
Tightening torque 25 Nm (18 lbf ft).
|
|
10.
|
Plug in the pressure sensor connectors.
|
|
12.
|
Connect an exhaust hose, start the engine and let it run for 30 seconds before turning it off.
|
|
13.
|
Check the oil level after 3-5 minutes. Top up with oil as necessary.
|
|
14.
|
Fit the upper engine cover.
|
