PRE-RELEASE
Engine mounting, right
| Engine mounting, right |
| To remove |
| 1. |
Cover the wings and raise the car.
|
|
| 2. |
CV:
Remove the cross brace, see Chassis reinforcement, front subframe, CV
|
|
| 3. |
Undo the bolts on the power steering pipe clamps on the subframe.
|
|
| 4. |
Fit
83 96 152 Centring kit, engine
to the subframe. See also
Centring tool, engine and subframe
.
|
|
| 5. |
Undo the rear bolts securing the torque arm.
|
|
| 6. |
Raise the centring drift bolts so that the slits in the adjustment bolts are fully visible.
|
|
| 7. |
Lower the car and remove the upper engine cover.
|
|
| 8. |
Remove the turbocharger intake hose, unplug the mass air flow sensor connector.
|
|
| 9. |
Remove the air cleaner cover and the air cleaner. Detach the inlet hose and remove the air cleaner casing.
|
|
| 10. |
Remove the engine pad from the body and the bracket.
|
|
| To fit |
| 1. |
Fit and adjust the engine pad to the body. Tighten the bolts between the engine pad and the bracket. The engine pad and bracket should be aligned with each other.
Tightening torque, body 40 Nm +60° (30 lbf ft +60°) Tightening torque, bracket 70 Nm +60° (52 lbf ft +60°) 
|
||||||||||
| 2. |
Fit the air filter housing and intake hose. Fit the air filter and filter housing lid.
|
|
| 3. |
Plug in the mass air flow sensor connector and fit the turbocharger intake hose.
|
|
| 4. |
Fit the upper engine cover.
|
|
| 5. |
Raise the car, remove
83 96 152 Centring kit, engine
and tighten the rear bolts securing the torque arm.
Tightening torque 70 Nm + 90° (52 lbf ft +60°) 
|
|
| 6. |
Fit the power steering pipe to the subframe.
|
|
| 7. |
CV:
Fit the cross braces. See Chassis reinforcement, front subframe, CV
|
|
| 8. |
Lower the car and remove the wing protectors.
|
|
