Drive shaft seal, left-hand
|
|
Drive shaft seal, left-hand
|
|
1.
|
Raise the car and remove the wheel.
Z19
: Remove the lower engine cover.
|
|
3.
|
Undo the clips on the brake hose and the ABS cable fasteners.
|
|
4.
|
Remove the bolt holding the ball joint to the steering swivel member. Prise loose and lower the swivel arm. Fix it in this position with a
83 95 238 Wedge
placed between the swivel arm and the anti-roll bar.
|
|
5.
|
Turn the wheel to the right to facilitate removal of the drive shaft. Grip the spring strut and pull so that the drive shaft comes with it. Then lower it in front of the swivel arm. Place a receptacle under the gearbox to avoid oil spill on the floor.
|
Important
|
|
Exercise caution; make sure that the tripod does not come loose from the inboard universal joint driver (aut).
|
|
|
|
|
3.
|
Make sure that the drive shaft is clean and then align it with the tool.
|
Important
|
|
Fit the drive shaft in the gearbox until about 20 mm remains and extract the tool before the shaft's sealing surface reaches the shaft seal.
|
|
|
|
|
4.
|
Push in the rest of the shaft until the circlip clicks in.
|
|
5.
|
Fit the ball joint to the steering swivel member and tighten.
Tightening torque 50 Nm (37 lbf ft)
Warning
|
|
Make sure the steering swivel pin is visible above the steering swivel member before fitting the bolt.
|
|
|
|
|
|
|
|
6.
|
Fit the brake hose in the mounting on the steering swivel member and fit the clip as well as the two mountings for the ABS lead.
|
