Airbag, side (333Db, 333Pb), CV
|
|
Airbag, side (333Db, 333Pb), CV
|
Warning
|
|
|
|
|
|
|
|
Warning
|
|
The battery's ground cable must be removed before the positive cable. Wait for at least 1 minute after disconnecting the battery before beginning any work on the airbag system. Otherwise the airbag may be deployed unintentionally and this can cause fatal/severe personal injuries.
|
|
|
|
|
|
|
1.
|
Set the seat to the front highest position.
|
|
2.
|
Turn the ignition key to the position LOCK.
|
|
5.
|
Release the backrest upholstery hooks from the frame.
Fold the upholstery forward.
|
|
6.
|
Remove the connector from the seat.
|
|
7.
|
Open the connector.
|
|
8.
|
Remove the airbag connector from the large connector.
|
|
9.
|
Remove the wiring harness from the lower part of the seat frame.
|
|
10.
|
Open the flexi hose and remove the airbag wiring harness.
|
|
11.
|
Remove the airbag wiring harness from the seat back frame.
|
|
12.
|
Remove the airbag from the back frame.
|
|
Warning
|
|
Torn backrest upholstery must not be repaired and refitted. The resistance of the upholstery is very carefully calculated as regards the side airbag and must not be changed.
|
|
|
|
|
|
|
1.
|
Fit the airbag to the back frame.
Tightening torque 8 Nm (6 lbf ft)
|
|
2.
|
Fit the airbag wiring harness to the seat back frame.
|
|
3.
|
Lay the airbag wiring harness in the flexi hose.
|
|
4.
|
Fit the wiring harness to the lower part of the seat frame.
|
|
5.
|
Fit the airbag connector in the large connector.
|
|
7.
|
Fit the connector to the seat.
|
|
11.
|
Return the seat to the correct version.
|
|
13.
|
Turn ON the ignition and check the airbag system and control module using the diagnostic tool as follows:
Connect the diagnostics instrument to the diagnostics socket under the dashboard. Delete any trouble codes.
Switch off the ignition and then on again. Wait at least 1 minute with the ignition switched on.
Check whether a diagnostic trouble code is displayed:
If a diagnostic trouble code is displayed:
Carry out fault diagnosis according to the instructions under respective trouble codes.
If no diagnostic trouble code is displayed:
Fitting completed correctly. Disconnect the diagnostics instrument.
|
