Impact sensor, front (332FL, 332FR)
|
|
Impact sensor, front (332FL, 332FR)
|
Warning
|
|
|
|
|
|
|
|
1.
|
Dismantle the front
bumper casing
.
|
Warning
|
|
The battery's ground cable must be removed before the positive cable. Wait for at least 1 minute after disconnecting the battery before beginning any work on the airbag system. Otherwise the airbag may be deployed unintentionally and this can cause fatal/severe personal injuries.
|
|
|
|
|
|
|
|
2.
|
Turn the ignition key to LOCK. Unplug the impact sensor.
|
|
3.
|
Dismantle the impact sensor by loosening the screws a few turns. Press together the locking clips on the inner part of the sensor. Press the outer part of the sensor towards the centre of the car and pull out the sensor.
|
|
1.
|
Fit the impact sensor by placing the sensor in position. Pull out the outer part of the sensor to the right position. Tighten the screws.
Tightening torque 9 Nm (7 lbf ft)
|
|
2.
|
Connect the impact sensor's connector.
|
|
5.
|
Turn ON the ignition and check the airbag system and control module using the diagnostic tool as follows:
Connect the diagnostic tool to the data link connector under the dashboard. Delete any diagnostic trouble codes.
Turn the ignition OFF and then ON again. Wait at least 1 minute with the ignition on.
Check whether a diagnostic trouble code is displayed:
If a diagnostic trouble code is displayed:
Carry out fault diagnosis according to the instructions under respective trouble codes.
If no diagnostic trouble code is displayed:
Fitting completed correctly. Disconnect the diagnostics instrument.
|
