SAAB WIS ONLINE

PRE-RELEASE

Rear side trim, CV

Rear side trim, CV

To remove


1. Remove the rear seat back rest and seat cushion .

2. Remove the speaker grille. Use 82 93 474 Removal tool .


3. Remove the rear side trim screw.

4. Lift the side trim upwards. Retain the rubber covers.

5. Detach the speaker cables.

6. Remove the door module connector.


Important

Take care when releasing the locking mechanism on the connector so as not to damage the connector. Pull the halves straight apart to avoid bending the pins. For further information regarding connectors, refer to Connectors, handling and inspection .



To fit

Note

Check that the damp protection is intact. Broken or loose damp protection must be replaced.



1. Connect the door module.


Important

Take care when plugging in the connector so as not to damage or press out the pins/sleeves in the connector. For further information regarding connectors, refer to Connectors, handling and inspection .


2. Connect the speaker cable.

3. Hook the side trim into the guide and press down. Check that the rubber covers are in place.

4. Fit the screw fastening the side trim.


5. Fold the inner lip of the door opening seal over the front edge of the side trim.


6. Lift the bracket on the soft top cover seal over the side trim.

7. Fit the speaker grille.

8. Fit the rear seat seat cushion and back rest .

9. Cars with pinch protection: Carry out pinch protection programming .


PRE-RELEASE