PRE-RELEASE
Thermostat housing with coolant connection
| Thermostat housing with coolant connection |
| To remove |
| 1. |
Open the bonnet
|
|
| 2. |
Drain the coolant
Place a receptacle underneath Open the drain screw (arrow) 
|
|
| 3. |
Remove the top engine cover
Unscrew the lid on the oil filler connection 2x Unscrew Screw on the lid on the oil filler connection |
|
| 4. |
Remove the coolant hose at the top (1) from the thermostat housing
|
|
| 5. |
Remove the thermostat housing (4)
Undo the cable set connector (3) 2x Unscrew Remove the throttle module preheating hose (2) 
|
|
| 6. |
Clean the sealing surfaces.
|
|
| 7. |
Fit the thermostat housing
Change the seal Fit the throttle module preheating hose 2x Tighten bolt - Tightening torque 20 Nm Connect cable set connector |
|
| 8. |
Fit the coolant hose at the top
|
|
| 9. |
Close the coolant drain screw
|
|
| 10. |
Fit the top engine cover
Unscrew the lid on the oil filler connection 2x Tighten bolt - Tightening torque 8 Nm Screw on the lid on the oil filler connection |
|
| 11. |
Fill with coolant
Instruction: Fill and bleed the cooling system - See Cooling system, filling and bleeding Observe the prescribed amount of coolant |
|
| 12. |
Close the bonnet
|
|
