SAAB WIS ONLINE

PRE-RELEASE

Camshaft housing, Z19DTH

Camshaft housing, Z19DTH

Warning

The work involved in removing the fuel pipe requires working with the vehicle's fuel system. The following points should therefore be heeded in conjunction with these measures:

• Have a class BE fire extinguisher on hand! Be aware of the risk of sparks, i.e. in connection with electric circuits, short-circuiting, etc.

• Absolutely No Smoking!

• Ensure good ventilation! If there is approved ventilation for evacuating fuel fumes then this must be used.

• Wear protective gloves! Prolonged exposure of the hands to fuel can cause irritation to the skin.

• Wear protective goggles.


To remove

Warning

Diesel under high pressure! So wait for at least one minute after switching off the engine before starting work in the fuel system. Diesel fumes are explosive and can cause severe burn injuries.


Important

Always use wing covers when working in the engine bay.



1. Remove Timing belt in-car Z19DTH

2. Remove the turbocharger delivery pipe upper bracket.


3. Remove the brake servo hose from the vacuum pump and bend aside.


4. Detach the vacuum hoses from the pump and the turbocharger control valve. Detach the vacuum pipe from the camshaft housing and oil trap bracket.


5. Undo the crankcase ventilation hose from the cylinder head.

6. Remove the cable duct retaining screws.


7. Remove the following connectors:

7.a. Camshaft position sensor (555).

7.b. Injectors (206).

7.c. Fuel pressure sensor (653).

7.d. Fuel pressure control valve (652a)

8. Fold away the engine wiring harness.

9. Remove the fuel delivery pipe between the pump and the fuel rail.


Important

If the injectors are to be refitted, mark them up so that they are refitted to the same cylinder.

If new injectors are to be fitted, read the identification code on the top and check that they are suitable for the engine control module in question.


10. Remove Injector (206), Z19DTH .


11. Detach and move aside the fuel rail.


12. Undo and remove the camshaft housing and guide sleeves. Loosen bolts alternately as illustrated.



To fit


1. Clean the cylinder head and camshaft housing sealing surfaces from any gasket residue.

2. Fit the guide sleeves and fit a new gasket onto the cylinder head.


Important

Check that all rocker arms are positioned correctly on the valve stems.



3. Fit the camshaft housing, tighten the bolts alternately. Make sure the guide sleeves are positioned correctly in the camshaft housing.

Tightening torque 25 Nm (15 lbf ft).


4. Fit the fuel rail.


5. Fit Injector (206), Z19DTH .


6. Fit the fuel delivery pipe between the pump and the fuel rail.

Tightening torque 25 Nm (18 lbf ft).


7. Fit the following connectors:

7.a. Camshaft position sensor (555).

7.b. Injectors (206).

7.c. Fuel pressure sensor (653).

7.d. Fuel pressure control valve (652a)


8. Fit the cable duct retaining screws and fix the wiring harness.

9. Fit the crankcase ventilation hose onto the cylinder head.


10. Fit the vacuum pipe onto the camshaft housing and the oil trap bracket. Connect the hoses to the pump and turbocharger control valve.

11. Fit the brake servo hose to the vacuum pump.


12. Fit the bracket to the turbocharger intake pipe.


13. Fit Timing belt in-car Z19DTH .


PRE-RELEASE