SAAB WIS ONLINE

PRE-RELEASE

Engine management system EDC16 (Part 4/4)

Engine management system EDC16 (Part 4/4)


List of components

No. Name location Illus.
Components
136 Oxygen sensor,
229 Main relay, engine control system in engine bay electrical centre 342
271 Heated oxygen sensor element, integrated in the oxygen sensor
342 Underhood electrical centre 342 (UEC) , next to the battery 1
398a Glow plug, cylinder 1, on upper rear section of engine
398b Glow plug, cylinder 2, on upper rear section of engine
398C Glow plug, cylinder 3, on upper rear section of engine
398d Glow plug, cylinder 4, on upper rear section of engine
595 Control module, EDC16, between the front spoiler and right-hand wheel housing A B
596 Control module, glow plug, on the side of the battery cover
602F Exhaust temperature sensor, front, component: in the inlet to the first catalytic converter connector: on the bracket beside the turbo
602R Exhaust temperature sensor, rear, component: in the front edge of the rear catalytic converter connector: on the bulkhead partition below the coolant reservoir
606 EGR solenoid unit, under the throttle body
744 Pressure sensor, exhaust system, on the bulkhead partition below the coolant reservoir
6-pin connector
H6-1 Behind field rail
11-pin connector
H11-1 On RH side of engine by the fuel pump
Crimp connections
J265 Approx. 30 mm from branching point intake air sensor towards the engine control module
J266 Approx. 140 mm from branching point intake air sensor towards the engine control module
J267 Approx. 100 mm from connector A to the engine control module
J270 Approx. 200 mm from branching point starter motor towards the reversing light switch
J271 Approx. 100 mm from branching point starter motor towards the reversing light switch
J273 Approx. 50 mm from branching point starter motor towards the engine control module
J274 Approx. 100 mm from branching point starter motor towards the engine control module
J278 SOP: in branching point glow plug control module Rev.1: Approx. 100mm from branching point electrical centre in engine bay towards reversing light switch
J280 SOP: Approx. 90mm from branching point glow plug control module towards battery Rev.1: Approx. 250mm from branching point electrical centre in engine bay towards reversing light switch
Grounding points
G2 On the side of the left structure strut by the connector bracket


PRE-RELEASE