PRE-RELEASE
Fluid-cooled oil cooler
| Fluid-cooled oil cooler |
| To remove |
| 1. |
Remove the
Battery
and
Battery cover, bottom
.
|
|
| 2. |
Remove the upper engine cover.
|
|
| 3. |
Remove the lower spoiler shield (A). Detach the hose to the headlight washer (B) and unplug and remove the connector (C).
|
|
| 4. |
Place a receptacle under the car, connect a hose to the radiator and drain the coolant
|
|
| 5. |
Remove the cable guide bolt (A) and nuts (B) (1 bolt and 2 nuts). Lift off the guide from the studs.
|
|
| 6. |
Unplug the oil pressure sensor connector (C).
|
|
| 7. |
Detach the coolant hoses on the oil cooler and move them aside.
|
|
| 8. |
Place a receptacle under the engine to collect the oil and coolant.
|
|
| 9. |
Remove the oil cooler's retaining bolts to the engine block.
|
|||||||
| 10. |
Lift out the radiator and remove the oil pressure sensor (A).
|
|
| To fit |
| 1. |
Fit the oil pressure sensor (A).
|
|
| 2. |
Fit new O-rings onto the oil cooler (B).
|
|
| 3. |
Position the oil cooler. Fit the oil cooler bolts (A).
Tightening torque 22 Nm (16 lbf ft) 
|
|||||||
| 4. |
Fit the oil cooler hoses and clamps (B).
|
|
| 5. |
Pressure test the cooling system, see
Cooling system, pressure testing
.
|
|
| 6. |
Fit the cable guide (A) and plug in the oil pressure sensor connector (C).
|
|
| 7. |
Replace the upper engine cover.
|
|
| 8. |
Fit the
Battery cover, lower section
and
Battery
.
|
|
| 9. |
Check the engine oil level and top up as necessary.
|
|
| 10. |
Fill coolant fluid and carry out
Bleeding the cooling system when working with the oil cooler
.
|
|
| 11. |
Connect the hose to the headlamp washer (B) and fit and plug in the connector (C). Fit the lower spoiler shield (A).
|
|
| 12. |
Carry out
Procedures after reconnecting the battery
.
|
|
