SAAB WIS ONLINE

PRE-RELEASE

Airbag, passenger (333P)

Airbag, passenger (333P)

Warning

Read through Safety and handling instructions and Before removing a control module before starting work.


To remove

Warning

The battery's ground cable must be removed before the positive cable. Wait for at least 1 minute after disconnecting the battery before beginning any work on the airbag system. Otherwise the airbag may be deployed unintentionally and this can cause fatal/severe personal injuries.



1. Ignition in position LOCK.

2. Remove the A-pillar trim on the passenger side.

3. Dismantle the dashboard's side cover.


4. Dismantle the nuts holding the dashboard on the passenger side.

5. Dismantle the scuff plate and the wheel housing's inner side panel.

6. Remove the glove box .

7. Remove the glove box's lock and decor trim.


8. Remove the airbag unit's 2 screws from the steering wheel member.


9. Remove the passenger airbag's 2 connectors.

10. Remove the ashtray .

11. Remove the centre console's front storage compartment.


12. Remove the ACC or MCC unit from the panel. Use 82 93 474 Removal tool .


13. Dismantle the nuts holding the dashboard.


14. Carefully pull out the dashboard a few centimetres from the A-pillar on the passenger side.


15. Remove the airbag upper and lower nuts from the dashboard.

16. Carefully lift down the airbag unit out from the dashboard.


To fit


1. Insert the passenger airbag and position it in the panel shell.


2. Fit the nuts on the passenger airbag's upper and lower edges.

Tightening torque 10 Nm (8 lbf ft)

3. Screw the dashboard into position.

4. Fit the nuts that hold the centre of the dashboard.


5. Fit the ACC or MCC to the panel.


6. Fit the centre console front storage compartment.


7. Fit the ashtray .

8. Connect the 2 passenger airbag connectors. Make sure the press on the back piece on the connector.


9. Fit the airbag unit's two screws on the steering wheel member.

Tightening torque 5 Nm (4)

10. Fit the glove box's lock and decor trim.


11. Refit the glove box .

12. Fit the wheel housing's inner side panel and scuff plate.


13. Fit the nuts holding the dashboard on the passenger side.



14. Fit the dashboard's side cover.

15. Fit the A-pillar's trim on the passenger side.

16. Connect the battery.

17. Turn ON the ignition and check the airbag system and control module using the diagnostic tool as follows:

Connect the diagnostic tool to the data link connector under the dashboard. Delete any diagnostic trouble codes.

Turn the ignition OFF and then ON again. Wait at least 10 seconds with the ignition on. Check whether a diagnostic trouble code is shown:

If a diagnostic trouble code is shown:

Carry out fault diagnosis according to the instructions under respective trouble codes.

If a diagnostic trouble code is not shown:

Disconnect the diagnostic tool.

18. Carry out Measures after disconnecting the battery .


PRE-RELEASE