PRE-RELEASE
B-pillar decor, front door
| B-pillar decor, front door |
| To remove |
| 1. |
Open the window fully.
|
|
| 2. |
Remove the
Front door trim
.
|
|
| 3. |
Remove the
Front window frame cover
.
|
|
| 4. |
Remove the outer weatherstrip using
82 93 474 Removal tool
.
|
|
| 5. |
Loosen the rear U-moulding and pull it up to gain access to the bolts.
|
|
| 6. |
Remove the screws.
|
|
| 7. |
Pull back on the decor and lift it away.
|
|
| To fit |
| 1. |
Place the U-moulding in the bottom of the rail. Press in the moulding using
82 93 474 Removal tool
. Fit the moulding down to the bottom screw hole. Align so that the corner of the decor fits against the rubber moulding.
|
|
| 2. |
Press down the decor against the side window while positioning the rear part of the decor.
|
|
| 3. |
Check the fit of the decor against the top corner.
|
|
| 4. |
Fit the decor screws. Take care when fitting the screws so that the moulding is not pulled out of the rail.
|
|
| 5. |
Press the moulding in place using
82 93 474 Removal tool
|
|
| 6. |
Fit the window frame cover
.
|
|
| 7. |
Plug in the door trim connector.
|
|
| 8. |
Check the operation of the window and the fit of the moulding.
|
|
| 9. |
Fit the outer weatherstrip.
|
|
| 10. |
Fit the
door trim
.
Cars with pinch protection : Perform Calibration of pinch protection . |
|
