PRE-RELEASE
Bonnet
| Bonnet |
| Removing |
| Note | ||
|
It is recommended that 2 people carry out steps 6-9. |
| 1. |
Open the bonnet.
|
|
| 2. |
Loosen the left bonnet seal a little.
|
|
| 3. |
Remove the clip on the cowl cover and lift the cover a little.
|
|
| 4. |
Loosen the washer hose clip and lift up the hose.
|
|
| 5. |
Part the washer hose's quick connector. Pull of the cover to the hinges.
|
|
| 6. |
Remove the bonnet's lower bolts.
|
|
| 7. |
Loosen the upper bolts.
|
|
| 8. |
Loosen the bonnet damper's upper mounting, locked using a clip. Lay the damper down so as not to damage the paintwork.
|
|
| 9. |
Lift off the bonnet.
|
|
| Fitting |
| Note | ||
|
It is recommended that 2 people carry out steps 1, 2, and 3. |
| 1. |
Lift the bonnet back into place.
|
|
| 2. |
Fit the bolts
|
|
| 3. |
Assemble the bonnet damper's upper mounting in the bonnet. Tighten the bolts.
|
|
| 4. |
Fit the hose on the hinge cover.
|
|
| 5. |
Fit the hinge covers. Make sure the clips engage properly.
|
|
| 6. |
Connect the washer hose to the quick connector. Place the washer hose under the cowl cover.
|
|
| 7. |
Fit the washer hose's clips under the cowl cover.
|
|
| 8. |
Fit the cowl cover's clips
|
|
| 9. |
Fit the rear bonnet seal.
|
|
| 10. |
Check the bonnet's alignment and the function of the bonnet lock and washers.
|
|
