PRE-RELEASE
Knock sensor, removing and fitting
| Knock sensor, removing and fitting |
| To remove |
| 1. |
Take off the knock sensor cable set connector (1).
|
|
| 2. |
Remove the knock sensor (2) from the engine block.
Caution The knock sensor tightening torque must be maintained under all circumstances or operating disturbances may arise. |
|
| To fit |
| 1. |
Fit the knock sensor to the engine block - tightening torque 20 Nm.
|
|
| 2. |
Connect the knock sensor cable set connector - note the cable routing.
|
|
