PRE-RELEASE
Replacing gear lever knob
| Replacing gear lever knob |
| To remove |
| 1. |
Cover the ignition switch and the area surrounding the gear lever with a cloth or the like.
|
|
| 2. |
Use a screwdriver to remove the emblem.
|
|||||||
| 3. |
Cut away the rubber protector in the centre.
|
|
| 4. |
Mark and drill a 4 mm hole 5 mm deep into the knob, 3 mm from the edge as illustrated.
|
|||||||||
Warning
| 5. |
Pull of the knob by screwing in a self-threading plate screw with flat tip (25 x 5.5 mm) into the hole.
|
|
| To fit |
| 1. |
Apply glue on the knob as illustrated. Use
Thread locking adhesive, Loctite 270
.
|
|
| 2. |
Fit the knob to the gear lever. Make sure the spring and foam ring are correctly situated.
|
|
| 3. |
Fit the emblem on the gear lever knob. Do not operate the lever until the adhesive has dried (approx. 30 min).
|
|
| 4. |
Remove the covering and vacuum up any swarf or the like.
|
|
