PRE-RELEASE
Bumper member, rear
| Bumper member, rear |
| To remove |
| 1. |
Raise the car.
|
|
| 2. |
Remove
Bumper shell, rear, 4D
or
Bumper shell, rear, 5D
.
|
|
| 3. |
Remove the bumper member nuts. If the car is damaged, it may be necessary to cut out a piece to reach the nuts.
|
|
| To fit |
| Note | ||
|
The rear frame member does not have any spacers on older cars. New spacers must therefore be fitted when changing the bumper member. |
| 1. |
5D
: Fit the spacers onto the studs.
Put in the bumper member. Guide in the member first through the guide hole on the top left-hand side. Fit the bumper member nuts. 
|
|
| 2. |
Fit
Bumper shell, rear, 4D
or
Bumper shell, rear, 5D
.
|
|
| 3. |
Lower the car.
|
|
