PRE-RELEASE

Oil pump sealing ring, change

To remove

1.	Remove the timing belt. See Timing belt in-car Z19DT and Timing belt in-car Z19DTH respectively.

2.	Remove the timing belt pulley. Use 32 025 006 Crankshaft holder in combination with 83 95 360 Holding tool, crankshaft pulley . Note The bolt has a left-hand thread.

3.	Remove the oil pump sealing ring by prising it loose from the oil pump with a suitable tool. Make sure the sealing surfaces are not damaged.

4.	Clean the sealing surfaces.

To fit

1.	Moisten the sealing ring lip with a little silicone grease (white) and fit the oil pump sealing ring. Use 32 025 014 Oil pump seal fitting tool .

2.	Fasten the belt pulley to 32 025 006 Crankshaft holder .

3.	Fit the timing belt pulley. Use 32 025 006 Crankshaft holder in combination with 83 95 360 Holding tool, crankshaft pulley . Tightening torque 340 Nm (251 lbf ft)

4.	Remove the special tool.

5.	Fit the timing belt. See Timing belt in-car Z19DT and Timing belt in-car Z19DTH respectively.

6.	Check the engine oil level and top up as necessary. See Recommended oil grade .

PRE-RELEASE

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.

Our Friends