PRE-RELEASE
Mounting, actuator, combustion circulation (403), Z19DTH
| Mounting, actuator, combustion circulation (403), Z19DTH |
| Important | ||
|
Always use wing covers when working in the engine bay. |
||
| To remove |
| 1. |
Remove the upper engine cover, insulation and battery cover. Detach the negative battery cable.
|
|||||||||||||||
Warning
| 2. |
Undo the oil trap upper hoses. The right-hand hose has a quick coupling to the oil trap. Hold the black plastic ring and pull up the connection.
|
|
| 3. |
Remove the nuts and bolts holding the oil trap bracket and bend it aside.
|
|
| 4. |
Remove the actuator, prise the control arm carefully away from the ball joint. Remove the actuator connector.
|
|
| To fit |
| 1. |
Plug in the actuator connector and fit the actuator. Press the control arm onto the ball joint with a suitable pair of pliers.
|
|
| 2. |
Bend the oil trap bracket back in place and fit the nuts and bolts.
|
|
| 3. |
Fit the oil trap upper hoses.
|
|
| 4. |
Connect the negative battery cable and fit the battery cover.
|
|
| 5. |
Remove the wing covers and restore car electrical functions, see
After disconnecting the battery
.
|
|
| 6. |
Connect an exhaust hose and start the engine. Check there are no leaks. Connect the diagnostic tool and clear any DTCs.
|
|
| 7. |
Fit the insulation and the upper engine cover.
|
|
