SAAB WIS ONLINE

PRE-RELEASE

Engine mounting, right

Engine mounting, right

To remove


1. Raise the car.

2. CV: Remove Chassis reinforcement, front subframe, CV .

3. Fit 83 96 145 Centring fixture, subframe - engine on the engine's subframe and 83 96 152 Centring tool, power train with 32 025 059 Support . First remove the two long supports. Relieve the load from the engine.


4. Lower the car.

Important

When removing the air cleaner casing cover, be careful not to damage the brake vacuum pump sensor.


5. Remove the upper section of the air cleaner.


6. Remove the lower section of the air filter.


7. Remove the engine pad.


8. Remove the power steering pipe clip from the engine mounting.


9. Remove the engine mounting from the engine (some models do not have a lower bolt).

Note

The hole of the lower bolt is slotted.



To fit


1. Fit the engine mounting to the engine (some models do not have a lower bolt).

Tightening torque 93 Nm (69 lbf ft)


2. Fit the power steering pipe clip to the engine mounting.

3. Fit the engine pad.

Tightening torque to body: 50 Nm + 180° (37 lbf ft + 180°)

Tightening torque to engine mounting: 45 Nm + 90° (33 lbf ft+ 90°)


4. Fit the lower section of the air cleaner.


5. Fit the upper section of the air cleaner.


6. Raise the car.

7. Remove Centring fixture, subframe and Centring tool, power train.

8. CV: Fit Chassis reinforcement, front subframe, CV .

9. Lower the car.


PRE-RELEASE