SAAB WIS ONLINE

PRE-RELEASE

Branch connector, aerial signal, GPS

Branch connector, aerial signal, GPS

To remove


1. Carry out Diagnostic procedures before replacing control modules .

2. Remove OnStar control module (673), 5D , OnStar control module (673), 4D , OnStar control module (673), CV .

Important

Take care when releasing the locking mechanism on the connector so as not to damage the connector. Pull the halves straight apart to avoid bending the pins. For further information regarding connectors, refer to Connectors, handling and inspection .


3. Remove the nuts (A).


4. Lift out the branching piece for the aerial signal (B).


To fit


1. Position the aerial signal branching piece (B).


2. Fit the nuts (A).

Important

Take care when plugging in the connector so as not to damage or press out the pins/sleeves in the connector. For further information regarding connectors, refer to Connectors, handling and inspection .


3. Plug in the connector.

4. Fit OnStar control module (673), 5D , OnStar control module (673), 4D , OnStar control module (673), CV .


PRE-RELEASE