Impact sensor, side, front (328D, 328P)
|
|
Impact sensor, side, front (328D, 328P)
|
Warning
|
|
|
|
|
|
|
|
Warning
|
|
The battery's ground cable must be removed before the positive cable. Wait for at least 1 minute after disconnecting the battery before beginning any work on the airbag system. Otherwise the airbag may be deployed unintentionally and this can cause fatal/severe personal injuries.
|
|
|
|
|
|
|
1.
|
Turn the ignition key to the position LOCK.
|
|
3.
|
Dismantle the front and rear scuff plates.
|
|
5.
|
Fold under the carpet.
|
|
6.
|
Dismantle the side impact sensor by loosening the screws a few turns. Press together the locking clips on the rear part of the sensor. Press back the front part of the sensor and pull out the sensor.
|
|
7.
|
Dismantle the side impact sensor's connector.
|
|
1.
|
Connect the side impact sensor's connector.
|
|
2.
|
Fit the side impact sensor by placing the sensor in its position. Pull forward the front part of the sensor. Tighten the screws.
Tightening torque 6 Nm (4 lbf ft)
|
|
5.
|
Fit the front and rear scuff plates.
|
|
8.
|
Turn ON the ignition switch and check the airbag system and control module using the diagnostic tool as follows:
Connect the diagnostic tool to the data link connector under the dashboard. Delete any diagnostic trouble codes.
Turn the ignition OFF and then ON again. Wait at least 1 minute with the ignition on.
Check if any fault codes are displayed:
If a diagnostic trouble code is shown:
Carry out fault diagnosis according to the instructions under respective trouble codes.
If a diagnostic trouble code is not shown:
The assembly was successful. Disconnect the diagnostic tool.
|
