PRE-RELEASE
Upper radiator member, B284
| Upper radiator member, B284 |
| To remove |
| 1. |
Remove the battery cover. Remove the battery air duct. Pull up the washer fluid filling pipe.
|
|
| 2. |
Remove the upper retaining bolts on the headlamps.
|
|
| 3. |
Remove the bolts holding the member to the headlamp frame.
|
|
| 4. |
Remove the bolts to the middle stay.
|
|
| 5. |
Remove the clip for the bumper shell.
|
|
| 6. |
Remove the bolts for the turbo inlet pipe.
|
|
| 7. |
Undo the right-hand headlamp and angle it out somewhat.
|
|
| 8. |
Undo the radiator crossmember on the right-hand side. Pull back and lift it slightly so that it goes free from the AC pipe. Take care not to break the fastening lugs during removal.
|
|
| 9. |
Remove the horn connector.
|
|
| 10. |
To remove the radiator crossmember, undo the bonnet cable quick release coupling by first releasing the clip on the body and then separating the quick release coupling using a screwdriver.
|
|||||||||
Warning
| To fit |
| 1. |
Fit the bonnet lock cable quick release coupling where applicable and press the clip onto the body. Place the lock cable under the mounting.
|
|
| 2. |
Insert the crossmember from the left-hand side between the headlamp retaining lugs and the headlamp frame and under the bumper shell.
|
|
| 3. |
Put in place the right-hand headlamp.
|
|
| 4. |
Fit the horn connector.
|
|
| 5. |
Make sure the middle stay is located behind the crossmember. Pressing the stay to its correct location.
|
|
| 6. |
Move the crossmember forward and position it under the right-hand headlamp mountings. Lift the headlamp mountings slightly.
|
|
| 7. |
Adjust the crossmember so that its guide lugs are located as illustrated.
|
|
| 8. |
Put in all the bolts.
|
|
| 9. |
Tighten first the middle stay bolts to obtain the correct fit.
|
|
| 10. |
Fit the bolts holding the member to the headlamp frame.
|
|
| 11. |
Tighten the upper retaining bolts on the headlamps.
|
|
| 12. |
Fit the bumper shell clips.
|
|
| 13. |
Fit the bolts for the turbo inlet pipe.
|
|
| 14. |
Fit the washer fluid reservoir filling pipe. Fit the battery cover and the air tube.
Check the operation of the bonnet lock. |
|
