PRE-RELEASE
Tooth belt guide rollers, removing and fitting
| Tooth belt guide rollers, removing and fitting |
| To remove |
| 1. |
Remove the top of the tooth belt cover - see
Tooth belt cover top part, removing and fitting
.
|
|
| 2. |
Remove the multi-belt - see
Multi-belt, removing and fitting
.
|
|
| 3. |
Remove the multi-belt tensioning pulley - see
Tensioning device for multi-belt, removing and fitting
.
|
|
| 4. |
Remove the bottom of the tooth belt cover - see
Tooth belt cover bottom part, removing and fitting
.
|
|
| 5. |
Screw in the drive belt pulley bolt into the crankshaft.
|
|
| 6. |
Remove the camshaft sensor (1) from the cylinder head and put it to one side.
|
|
| 7. |
Turn the crankshaft in the direction of engine rotation to "ignition TDC for cylinder 1" (III). The markings on the camshaft gears must be in front of each other (I).
|
|
| 8. |
Fix the camshaft sprocket with KM-852
(83 96 319 Holder tool, fixing of camshaft sprocket Z18XE
) (II).
|
|
| 9. |
Undo the bolt on the drive belt tensioning pulley (IV) and turn the eccenter adjuster in the direction of the arrow (clockwise) until the pointer (1) is close to the left-hand stop.
|
|
| 10. |
Remove the tooth belt and put it to one side.
|
|
| 11. |
Remove the drive belt idler pulley on the intake side (1) from the cylinder head and the drive belt idler pulley on the exhaust side (2) from the engine pad bracket.
|
|
| To fit |
| 1. |
Fit the exhaust side idler pulley on the engine pad bracket - tightening torque 25 Nm.
|
|
| 2. |
Fit the intake side idler pulley on the cylinder head - tightening torque 25 Nm.
|
|
| 3. |
Put on the tooth belt - check that the pull side (I) is taut.
Caution Note the valve timing marks! |
|
| 4. |
Adjust the tooth belt tension - see
Tooth belt tension, setting
.
|
|
| 5. |
Fit the camshaft sensor to the cylinder head - fit the bolts with locking compound (red) - tightening torque 8 Nm.
|
|
| 6. |
Fit the bottom of the tooth belt cover - see
Tooth belt cover bottom part, removing and fitting
.
|
|
| 7. |
Fit the tensioning device for the multi-belt - see
Tensioning device for multi-belt, removing and fitting
.
|
|
| 8. |
Fit the multi-belts - see
Multi-belt, removing and fitting
.
|
|
| 9. |
Fit the top of the tooth belt cover - see
Tooth belt cover top part, removing and fitting
.
|
|
