PRE-RELEASE
Tooth belt tension, check
| Tooth belt tension, check |
| To remove |
| Note | ||
|
This procedure applies to tooth belts only. When fitting a new drive belt - see Tooth belt tension, setting . Check on a cold engine - room temperature. |
| 1. |
Disconnect the ground cable from the battery.
|
|
| 2. |
Remove the top of the tooth belt cover - see
Tooth belt cover top part, removing and fitting
.
|
|
| 3. |
Remove the multi-belt - see
Multi-belt, removing and fitting
.
|
|
| 4. |
Remove the right front wheel.
|
|
| 5. |
Remove the wing liner on the right-hand side.
|
|
| 6. |
Remove the multi-belt tensioning pulley - see
Tensioning device for multi-belt, removing and fitting
.
|
|
| 7. |
Remove the bottom of the tooth belt cover - see
Tooth belt cover bottom part, removing and fitting
.
|
|
| 8. |
Screw in the drive belt pulley bolt into the crankshaft.
|
|
| Checks |
| 1. |
Turn the crankshaft in the direction of engine rotation to "No. 1 cylinder TDC (III).
|
|
| 2. |
The markings on the camshaft sprocket must be in front of each other.
|
|
| 3. |
Turn the crankshaft slowly and evenly.
|
|
| 4. |
Fix the camshaft gears with KM-852 (II).
Check the fitting position of the coolant pump - adjust if necessary. The mark (2) on the coolant pump must correspond with the mark (1) on the engine block. 
|
|
| 5. |
Possibility I: The tooth belt tension is correct if the pointer (4) on the tooth belt tensioning pulley is about 4 mm to the left of the groove (3).
|
|
| 6. |
Possibility II: The tooth belt tension is correct if the pointer (6) on the tooth belt tensioning pulley corresponds with "USED" (5).
|
|
| 7. |
If the tooth belt tension is incorrect - see procedure
Tooth belt tension, setting
.
|
|
| To fit |
| 1. |
Remove the retaining bolt from the tooth belt sprocket and remove the blocking tool KM-852.
|
|
| 2. |
Fit the bottom of the tooth belt cover - see
Tooth belt cover bottom part, removing and fitting
.
|
|
| 3. |
Fit the tensioning device for the multi-belt - see
Tensioning device for multi-belt, removing and fitting
.
|
|
| 4. |
Fit the right-hand wing liner.
|
|
| 5. |
Fit the front right wheel
.
|
|
| 6. |
Fit the multi-belts - see
Multi-belt, removing and fitting
.
|
|
| 7. |
Fit the top of the tooth belt cover - see
Tooth belt cover top part, removing and fitting
.
|
|
| 8. |
Connect the ground cable to the battery.
|
|
