Oil pressure check, Z19DTR
|
|
Oil pressure check, Z19DTR
|
|
1.
|
Disconnect the negative cable from the battery.
|
|
4.
|
Remove the lower engine cover.
|
|
5.
|
Undo the cable clips (A) from the EHPS holder.
|
Important
|
|
Take care when releasing the locking mechanism on the connector so as not to damage the connector. Pull the connector straight out when unplugging avoid bending the pins. For further information regarding connectors, refer to Connectors, handling and inspection.
|
|
|
|
|
6.
|
Unplug the pressure sensor connector (B).
|
|
7.
|
Remove the pressure sensor (C).
|
|
10.
|
Fit the battery negative cable.
|
|
11.
|
Connect and exhaust hose and start the engine.
|
Note
|
|
Do not leave the engine running for longer than it takes to check the specified oil pressures.
|
|
|
12.
|
Measure the oil pressure:
|
|
|
•
|
Warm engine >4 bar at 4000 rpm.
|
|
13.
|
Switch off the engine.
|
|
14.
|
Disconnect the negative cable from the battery.
|
|
1.
|
Fit the pressure sensor (C).
Tightening torque 30 Nm (22 lbf ft)
|
Important
|
|
Take care when plugging in the connector so as not to damage or press out the pins/sleeves in the connector. For further information regarding connectors, refer to Connectors, handling and inspection.
|
|
|
|
|
2.
|
Plug in the pressure sensor connector (B).
|
|
3.
|
Fit the cable clips (A) to the EHPS holder.
|
|
4.
|
Fit the lower engine cover.
|
|
7.
|
Fit the battery negative cable.
|
|
8.
|
Connect an exhaust extractor hose and start the engine to check everything runs correctly.
|
|
9.
|
Check engine oil level, top up as necessary to the prescribed level.
|
