PRE-RELEASE
Engine compression test
| Engine compression test |
| To remove |
| 1. |
Man:
Put the gear lever in neutral.
Aut:
Put the selector lever in position P. Remove the key from the ignition switch.
|
|
| 2. |
Remove the
Spark plugs
.
|
|
| 3. |
Remove relay no. 8 in the
Underhood electrical centre 342
.
|
|
| 4. |
Connect
83 93 886 Diagnostics cable, LH system
to relay holder sleeves 87 and 30. Make sure that the switch is in the OFF position.
|
|
| 5. |
Fit the Motometer compression tester for petrol engines to cylinder 1 with a new card.
|
|
| 6. |
Run the starter motor using the test lead switch until the needle stops rising.
|
|
| 7. |
Repeat the procedure on the other cylinders. For minimum compression, see
Pistons
.
|
|
| To fit |
| 1. |
Fit the
Spark plugs
.
|
|
| 2. |
Remove the test cable and put back relay no. 8.
|
|
