PRE-RELEASE
Rear crankshaft seal
| Rear crankshaft seal |
| To remove |
| 1. |
Remove the
Power train
or
Power train, 4WD
.
|
|
| 2. |
Remove
Camshaft covers, removed engine.
|
|
| 3. |
Remove
Timing cover.
|
|
| 4. |
Remove
Oil sump
.
|
|
| 5. |
Remove the flywheel or driver plate using
EN-46106 Flywheel locking attachment
as a holding tool.
|
|
| 6. |
Remove the rear seal of the crankshaft.
|
|
| 7. |
Clean the parts and remove gasket residue.
|
|
| To fit |
| 1. |
Apply a 2 mm thick bead of
93 160 951 Flange sealant
as illustrated.
|
|
| 2. |
Fit the crankshaft's rear seal using
EN-47839 Fitting tool
as a guide.
Tightening torque 10 Nm (7 lbf ft) 
|
|
| 3. |
Fit the flywheel or driver plate using
EN-46106 Flywheel locking attachment
as a holding tool. Apply
Thread locking adhesive, Loctite 270
to the bolts.
Tightening torque: 30 Nm +45° (22 lbf ft +45° ) 
|
|
| 4. |
Fit the
Oil sump
.
|
|
| 5. |
Fit
Timing cover.
|
|
| 6. |
Fit
Camshaft covers, removed engine
.
|
|
| 7. |
Fit the
Power train
or
Power train, 4WD
.
|
|
