PRE-RELEASE
Starter motor, Z19
| Starter motor, Z19 |
| To remove |
| 1. |
Remove the battery cover.
|
|
| 2. |
Disconnect the negative battery cable.
|
|
| 3. |
Remove the upper bolts from the starter motor.
|
|
| 4. |
Remove the bracket from the coolant pipes and wiring harness.
|
|
| 5. |
Raise the car.
|
|
| 6. |
Remove the lower engine cover.
|
|
| 7. |
Detach the starter motor connecting cables.
|
|
| 8. |
Detach the ground cable from the lower stud on the starter motor.
|
|
| 9. |
Remove the lower stud from the starter motor.
|
|
| 10. |
Lower the starter motor to the left through the wheel housing.
|
|
| To fit |
| 1. |
Lift the starter motor into place and thread the lower stud.
|
|
| 2. |
Lower the car.
|
|
| 3. |
Fit the bracket to the coolant pipes and wiring harness.
|
|
| 4. |
Fit the upper bolts to the starter motor.
Tightening torque 24 Nm (18 lbf ft) |
|
| 5. |
Raise the car.
|
|
| 6. |
Tighten the lower stud.
Tightening torque 24 Nm (18 lbf ft) |
|
| 7. |
Connect the cables to the starter motor.
|
|
| 8. |
Attach the ground cable to the lower stud.
|
|
| 9. |
Fit the lower engine cover.
|
|
| 10. |
Lower the car.
|
|
| 11. |
Fit the negative battery cable.
|
|
| 12. |
Fit the battery cover.
|
|
| 13. |
Reset the car; see
Procedures after battery disconnection
.
|
|
