PRE-RELEASE
Rear floor assembly, CV
| Rear floor assembly, CV |
| Removing |
| 1. |
Position the car in an aligning bench and align if necessary
|
|
| 2. |
Remove the
Rear bumper abutment, CV
.
|
|
| 3. |
Cut the floor as indicated by the marks. The cut must be made so that the replacement piece overlaps by approximately 20 mm.
|
|
| 4. |
Drill out the spot-welds.
|
|
| 5. |
Remove the floor and align any damaged sheet metal or panels.
|
|
| Fitting |
| 1. |
Grind all the surfaces that are to be welded.
|
|
| 2. |
Apply welding primer to the surfaces to be plug or spot welded.
|
|
| 3. |
Cut and align the rear floor. The cut must be made so that the replacement piece overlaps by approximately 20 mm. Secure with clamps.
|
|
| 4. |
Weld the floor in place.
|
|
| 5. |
Smooth off the welds.
|
|
| 6. |
Remove any remaining welding primer. Welding primer reduces adhesion of paint, filler and sealant.
|
|
| 7. |
Apply primer to all bare metal surfaces.
|
|
| 8. |
Seal joints and seams with sealant.
|
|
| 9. |
Apply PVC substitute on the underside of the floor.
|
|
| 10. |
Apply a thin anti-corrosion agent to the members and cavities after painting
|
|
| 11. |
Fit the
Rear bumper abutment, CV
.
|
|
