PRE-RELEASE
Seat member, CV
| Seat member, CV |
| 1. |
Position the car in an aligning bench and cross-measure if necessary.
|
|
| 2. |
Drill out the spot welds.
|
|
| 3. |
Drill out the spot welds.
|
|
| 4. |
Grind away the seam welds to the seat member.
|
|
| 5. |
Bend up the corners slightly to easier remove the seat member.
|
|
| 6. |
Knock loose the seat member and straighten any deformed metal.
|
|
| 7. |
Grind all surfaces that are to be welded.
|
|
| 8. |
Drill holes for plug-welding in the spare part.
|
|
| 9. |
Apply welding primer to the surfaces to be spot and plug welded. Use Teroson Zink Spray.
|
|
| 10. |
Place the seat member in fitting position and secure with a few welding clamps.
|
|
| 11. |
Adjust the corner that is overlapping the seat member.
|
|
| 12. |
Spot and plug weld the seat member.
|
|
| 13. |
Seam weld the seat member.
|
|
| 14. |
Wash away surplus welding primer. Welding primer reduces the adhesion of paint, filler and sealant.
|
|
| 15. |
Apply primer to all bare metal surfaces. Use Standox 1K.
|
|
| 16. |
Seal joints and seams with sealant. Use 1K-PUR.
|
|
| 17. |
Apply anti-corrosion agent to internal surfaces after painting. Use Terotex HV 400.
|
|
