SAAB WIS ONLINE

PRE-RELEASE

Camshaft cover, removing and fitting

Camshaft cover, removing and fitting

To remove



1. Remove the engine cover.

2. Remove the ignition module - see procedure Ignition module, removing and fitting .

3. Remove the crankcase ventilation hoses (3) from the camshaft cover.

4. Remove the cable set connector (4) from the sensor for the coolant temperature.

5. Remove the coolant line (5) from the thermostat housing, camshaft cover and intake manifold - lay the coolant line to one side.

6. Remove the camshaft cover (6) from the cylinder head.


To fit


1. Clean the sealing surfaces and remove remains of sealant.

Apply adhesive sealant (black) to the sealing surfaces (2).

2. Fit new gaskets (3) to the camshaft cover - the gasket sealing lips must be inserted into the groove in the camshaft cover.

3. Fit the camshaft cover onto the cylinder head - tightening torque 8 Nm.


4. Fit the engine vent hoses to the cylinder head.

5. Fit the ignition module - see procedure Ignition module, removing and fitting .

6. Fit the engine cover.


PRE-RELEASE