PRE-RELEASE
Crankshaft rear sealing ring, change
| Crankshaft rear sealing ring, change |
| To remove |
| 1. |
Remove the manual gearbox
Instruction: remove the manual gearbox - see Gearbox, removing an fitting, F 17 |
|
| 2. |
Remove the clutch
Instruction: remove the clutch - see Clutch - overview, F17 |
|
| 3. |
Remove the flywheel
Use 83 94 868 Flywheel locking attachment. 6x Undo the bolt 
|
|
| 4. |
Remove the crankshaft rear sealing ring
Important: do not damage sealing surface Place a receptacle underneath Prise loose the crankshaft rear sealing ring |
|
| 5. |
Clean the sealing service
|
|
| 6. |
Fit the crankshaft rear sealing ring
Moisten the sealing lip with grease Place KM-235-D ( 83 96 293 Fitting tool rear crankshaft seal, Z18XE ) (1) onto the crankshaft journal Push the sealing ring (2) onto KM-235-D ( 83 96 293 Fitting tool rear crankshaft seal, Z18XE ) Strike in the sealing ring flush - Use KM-658-1( 83 96 285 Fitting tool rear crankshaft seal, Z18XE ) (3) 
|
|
| 7. |
Clean the threads.
6x Clean the threads - in the crankshaft |
|
| 8. |
Fit the flywheel
Instruction: Use new bolts 6x Tighten the bolt - Tightening torque 35 Nm + 30° + 15° - Use 83 94 868 Flywheel locking attachment . |
|
| 9. |
Clean the flywheel
|
|
| 10. |
Fit the clutch
Instruction: Fit the clutch - see Clutch - overview, F17 |
|
| 11. |
Fit the manual gearbox
Instruction: Fit the manual gearbox - see Gearbox, removing an fitting, F 17 . |
|
| 12. |
Check and adjust the engine oil level.
Note the prescribed engine oil volume |
|
