PRE-RELEASE

Crankshaft pulley

To remove

1.	Raise the car and remove the right front wheel.

2.	Remove the right wing liner.

3.	Mark the belt's direction of rotation. Unload the belt tensioner. Use a ½" puller and remove the poly-V-belt from the crankshaft pulley.

4.	Remove the bolt holding the crankshaft pulley using 83 95 360 Holding tool, crankshaft pulley (handle only) and EN-47981 Holding tool, pulley . Note The pulley is pressed onto the crankshaft.

5.	Remove the pulley using EN-47982 Puller and EN-47981 Holding tool, pulley .

To fit

1.	Clean the sealing surface of the pulley.

2.	Press the pulley onto the crankshaft using KM-J 41998 Fitting tool .

3.	Fit the bolt using 83 95 360 Holding tool, crankshaft pulley (handle only) and EN-47981 Holding tool, pulley . Tightening torque: 100 Nm + 150° (74 lbf ft + 150°)

4.	Fit the drive belt.

5.	Refit the right wing liner.

6.	Fit the right front wheel.

PRE-RELEASE

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.

Our Friends