SAAB WIS ONLINE

PRE-RELEASE

Fuel filler pipe

Fuel filler pipe

Warning

The work involved in removing the fuel pipe requires working with the vehicle's fuel system. The following points should therefore be heeded in conjunction with these measures:

• Have a class BE fire extinguisher on hand! Be aware of the risk of sparks, i.e. in connection with electric circuits, short-circuiting, etc.

• Absolutely No Smoking!

• Ensure good ventilation! If there is approved ventilation for evacuating fuel fumes then this must be used.

• Wear protective gloves! Prolonged exposure of the hands to fuel can cause irritation to the skin.

• Wear protective goggles.


Important

Be particulary observant regardning cleanliness when working on the fuel system. Loss of function may occur due to very small particles. Prevent dirt and grime from entering the fuel system by cleaning the connections and plugging pipes and lines during disassembly. Use 82 92 948 Plugs, A/C system assembly. Keep components free from contaminants during storage.


To remove


1. Drain the fuel tank if necessary. See Draining the fuel tank .

2. Remove the rear wheel .

3. Remove the Wing liner, rear .

4. Remove the fuel filler flap.

5. Raise the car.

6. Lower the rear section of the exhaust system. Suspend it with two 83 95 212 Strap .

7. Undo the filler pipe clamp.

8. Remove the filler pipe's and the ground cable's bolt.


9. Remove the filler pipe. Pull the pipe out of the fuel filler flap port.


To fit


1. Fit a new hose to the filler pipe.

2. Fit the filler pipe with heat shield. Tighten the clamp bolt.


3. Fit the filler pipe's and the ground cable's bolt.

4. Fit the fuel filler flap.

5. Fit the exhaust system.

6. Lower the car.

7. Fit the Wing liner, rear

8. Fit the Wheel .


PRE-RELEASE