PRE-RELEASE
Valve housing, B207
| Valve housing, B207 |
| To remove |
| 1. |
Remove the
Valve housing cover, B207
.
|
|
| 2. |
Detach the wiring harness for the solenoid valves. (The illustration shows how to use a screwdriver for detaching the different connectors.)
|
|
| • |
Detach 8 connectors from the solenoid valves (A).
|
| • |
Unplug the 2 connectors from the engine speed sensors. (B)
|
| • |
Remove the wiring harness from the 2 retaining clips. (C)
|
| 3. |
Unplug the engine speed sensors' connectors.
|
|
| • |
Detach the connectors from the two mountings. (D)
|
| 4. |
Remove the temperature sensor.
|
|
| • |
Remove the screw. (A)
|
| • |
Lift away the attaching plate. (B)
|
| • |
Remove the temperature sensor (C)
|
| 5. |
Move the wiring harness for the solenoid valves and the wiring harness for the engine speed sensors aside.
|
|
| 6. |
Remove the cover (A).
|
|
| • |
Remove the cover. (B)
|
| • |
Remove the gasket. (C)
|
| 7. |
Remove the valve housing.
|
|
| • |
Undo the screws in the specified order.
|
| • |
Remove the screws.
|
| 8. |
Lower the car to the floor.
|
|
| 9. |
Unhook the clutch rod. (A)
|
|
| 10. |
Carefully lift the valve housing upwards.
|
||||||||||
| To fit |
| 1. |
Clean the sealing surfaces
|
|
| 2. |
Clean the threads. (arrows)
|
|
| 3. |
Fit the valve housing.
|
|
| • |
Hook in the clutch rod. (A)
|
| • |
Fit 6 screws.
|
| 4. |
Raise the car.
|
|
| 5. |
Fit the cover.
|
|
| • |
Fit a new gasket. (C)
|
| • |
Fit the cover. (A)
|
| • |
Fit two screws. (B)
|
| 6. |
Finish fitting the valve housing.
|
|
| • |
Tighten the 8 screws (arrows) in the specified order.
Tightening torque 10 Nm (7 lbf ft) 
|
| 7. |
Fit the temperature sensor. (C)
|
|
| • |
Moisten the temperature sensor O-ring with gearbox oil.
|
| • |
Fit the attaching plate. (B)
|
| • |
Tighten the screw. (A)
Tightening torque 10 Nm (7 lbf ft) |
| 8. |
Plug in the engine speed sensors' connectors.
|
|
| • |
Attach the connectors to the two mountings (D).
|
| 9. |
Plug in the connector for the solenoid valves.
|
|
| • |
Secure the wiring harness in the 2 retaining clips (C).
|
| • |
Plug in the 2 connectors for the engine speed sensors (B).
|
| • |
Plug in the 8 connectors for the solenoid valves (A)
|
| 10. |
Fit the
Valve housing cover, B207
.
|
|
| 11. |
Upon valve housing replacement: Carry out
Adaptation, resetting
.
|
|
