PRE-RELEASE
Yaw sensor (658)
| Yaw sensor (658) |
| Important | ||
|
ESD-SENSITIVE COMPONENT |
||
|
Earth yourself by touching the car body before plugging in/unplugging components. Do not touch the component pins, see Removing electronic components . |
||
| To remove |
| 1. |
Remove
floor console
or
floor console, with UHP connection
.
|
|
| 2. |
Remove the air duct.
|
|
| 3. |
Loosen the adjustment and unhook the cables. Remove the cable ferrules from the console.
|
|
| 4. |
Move the front seats into their rearmost positions. Mark the position of the front centre console bolts. Remove the front bolts.
|
|
| 5. |
Move the seats into their forwardmost position. Remove the rear console bolts.
|
|
| 6. |
Lift up the console and remove the gyro sensor and unplug the connector.
|
|
| To fit |
| 1. |
Plug in the gyro sensor.
Tightening torque: 10 Nm (7.5 lbf ft) 
|
|
| 2. |
Fit the console. Make sure the front bolts align with the markings.
Tightening torque: 10 Nm (7.5 lbf ft) 
|
|
| 3. |
Connect the brake cables.
|
|
| 4. |
Adjust the cables.
|
|
| 5. |
Fit the air ducts.
|
|
| 6. |
Fit
floor console
or
floor console, with UHP connection
.
|
|
| 7. |
Park the car on a level surface.
|
|
| 8. |
Connect the diagnostic tool.
|
|
| 9. |
Select All -
Add / Remove -
Other Components -
Yaw Rate Sensor Calibration. Follow the instructions on the screen.
|
|
| 10. |
Disconnect the diagnostic tool.
|
|
