PRE-RELEASE
Rear bumper abutment, CV
| Rear bumper abutment, CV |
| 1. |
Position the car in an aligning bench and cross-measure if necessary.
|
|
| 2. |
Drill out the spot-welds.
|
|
| 3. |
Tap the rear bumper abutment loose and align any damaged sheet metal or panels.
|
|
| 4. |
Grind all the surfaces that are to be welded.
|
|
| 5. |
Drill holes for plug-welding in the spare part.
|
|
| 6. |
Apply welding primer to the surfaces to be spot and plug welded. Use Teroson Zink Spray.
|
|
| 7. |
Place the replacement piece in fitting position; align it exactly and secure it with welding clamps.
|
|
| 8. |
Close the bootlid and adjust the alignment.
|
|
| 9. |
Spot and plug weld the rear bumper abutment.
|
|
| 10. |
Wash away surplus welding primer. Welding primer reduces the adhesion of paint, filler and sealant.
|
|
| 11. |
Apply primer to all bare metal surfaces. Use Standox 1K.
|
|
| 12. |
Seal joints and seams with sealant. Use 1K-PUR.
|
|
| 13. |
Apply anti-corrosion agent to internal surfaces after painting. Use Terotex HV 40.
|
|
