PRE-RELEASE
Side window, door, CV
| Side window, door, CV |
| To remove |
| 1. |
Open the door window fully and then raise it approx. 10 cm.
|
|
| 2. |
Remove
Door trim, CV
.
|
|
| 3. |
Carefully pull out the fixing plugs from the rear portion of the outer weatherstrip. Carefully fold up the weatherstrip, starting at the rear and working towards the door mirror base.
|
|
| 4. |
Remove the inner weatherstrip.
|
|
| 5. |
Remove the water barrier.
|
|
| 6. |
Loosen the forward screw and remove the rear screw holding the door window. Lift out the door window.
|
|
| To fit |
| 1. |
If necessary lower the lift mechanism until the door window screws are accessible.
|
|
| 2. |
If necessary fit the plastic mount to the door window.
|
|
| 3. |
Manoeuvre the door window in from above and locate it in the mounting position.
|
|
| 4. |
Fit the rear screw and tighten the forward screw holding the door window.
|
|
| 5. |
Locate the outer weatherstrip in position and push the fixing plugs into place.
|
|
| 6. |
Fit the inner weatherstrip. Check that it is correctly located against the outer weatherstrip.
|
|
| 7. |
Test the operation of the door window and adjust if necessary, see
Adjustment of the door mirror base seal and windows
.
|
|
| 8. |
Fit the water barrier.
|
|
| 9. |
Fit
The door trim
.
|
|
| 10. |
Cars with pinch protection
: Perform
Calibration of pinch protection
|
|
