PRE-RELEASE
Rear crankshaft seal
| Rear crankshaft seal |
| To remove |
| 1. |
Remove the gearbox, see
Man: Complete gearbox B207 6 speed or Complete gearbox B284 4WD or Complete gearbox, B207 4WD Aut: Complete gearbox aut or Complete gearbox B284 4WD or Complete gearbox, B207 4WD |
|
| 2. |
Remove the pressure plate and clutch drive plate, see
Clutch assembly
.
|
|
| 3. |
Remove the driver plate or the
Flywheel
.
|
|
| 4. |
Carefully prise out the seal using a screwdriver.
|
|
| To fit |
| 1. |
Clean the sealing surfaces of gasket residue.
|
|
| 2. |
Position the
83 94 975 Fitting tools, rear crankshaft seal
protective collar on the crankshaft. Lubricate the new sealing ring with non-acidic Vaseline and position it on the fitting tool.
|
|
| 3. |
Position the fitting tool on the crankshaft. Drive in the sealing ring with the shaft and the narrow guide sleeve until it is flush with the timing cover. Remove the tool.
|
|
| 4. |
Fit the
Flywheel
or driver plate with new bolts.
|
|
| 5. |
Fit the pressure plate and the clutch drive plate, see
Clutch assembly.
|
|
| 6. |
Fit the gearbox, see
Man: Complete gearbox B207 6 speed or Complete gearbox B284 4WD or Complete gearbox, B207 4WD Aut: Complete gearbox aut or Complete gearbox B284 4WD or Complete gearbox, B207 4WD |
|
| 7. |
Check the oil level in the engine. Top up as necessary.
|
|
