SAAB WIS ONLINE

PRE-RELEASE

(TA248-1108) Check Engine lamp illuminated and DTC P1681, P0638 and/or P2135 set

TECHNICAL ADVICE - Quick information for your help
Bulletin Nbr: TA248-1108
Date: ........... March 2011
Market: All
Check Engine lamp illuminated and DTC P1681, P0638 and/or P2135 set

VEHICLES CONCERNED

Saab 9-3 SS, SC, CVMY07 and later, (mainly MY09 produced during late 2008) with L850 engine independent of engine variant..

BACKGROUND

Check engine lamp is illuminated, and DTC P1681, P0638, P2135 is stored in the T8 ECM. The root cause to the DTC is most likely caused by the sensitivity of the throttle body position sensor in combination with variables in throttle control strategy.

ACTION

If DTC P1681 is detected together with P0638 and/or DTC P2135, the throttle housing P/N 9318 9207 and gasket P/N9053 7718 could be replaced without further fault tracing.

If only DTC P1681 is detected proceed as follows:

Connect TECH 2 and start in the snap shot mode (throttle area (mm2), engine speed, and requested air).

Drive the vehicle on a flat road with constant speed and engine load to record the snap shot during driving.

If the value for the throttle is fluctuating during driving it is most likely a faulty throttle housing is the root cause and should be replaced together with gasket.

If the throttle area does not fluctuate, follow the fault tracing in WIS for DTC 1681 before further remedies.

PRE-RELEASE