PRE-RELEASE
Rear catalytic converter, 4WD
| Rear catalytic converter, 4WD |
| To remove |
| 1. |
Raise the car.
|
|
| 2. |
Undo the nuts on the exhaust pipe clamp (A).
|
||||||||||
| 3. |
Remove the rubber mountings (B).
|
|
| 4. |
Suspend the rear exhaust pipe with
83 95 212 Strap
(C) and remove the rubber mounting (D).
|
|
| 5. |
Remove the nuts (E) of the front catalytic converter.
|
|
| 6. |
Lower the exhaust system slightly and remove the front pipe complete with catalytic converter.
|
|
| To fit |
| 1. |
Fit the front pipe complete with catalytic converter.
|
|
| 2. |
Fit the flange with new gasket and new nuts (E) to the front catalytic converter.
Tightening torque 30 Nm (22 lbf ft) |
|
| 3. |
Fit the rubber mountings (B). Replace rubber mountings if necessary.
|
|
| 4. |
Tighten the clamp nut (A).
Tightening torque 40 Nm (30 lbf ft). |
|
| 5. |
Slacken 83 95 212 Strap (C) and fit the rubber mounting (D).
|
|
| 6. |
Lower the car.
|
|
| 7. |
Connect exhaust hoses and start the engine. Check that the exhaust system does not leak.
|
|
