SAAB WIS ONLINE

PRE-RELEASE

Exhaust system assembly, B207, 4WD

Exhaust system assembly, B207, 4WD

To remove


1. Raise the car.

2. Remove the bush bolts (A) and turn down the anti-roll bar (B).


3. Loosen the exhaust pipe clamp (A).


4. Remove the nut for the exhaust pipe mounting (A).


5. Undo the silencers from the rear mountings (A).


6. Remove the exhaust system.


To fit


1. Fit the exhaust system so that it hangs evenly.

2. Fit the nut for the exhaust pipe mounting (A).


3. Tighten the exhaust pipe clamp (A).

Tightening torque 40 Nm (30 lbf ft).


4. Turn up the anti-roll bar (B) and fit the bolts for the bushes (A).

Tightening torque 30 Nm (23 lbf ft).


5. Lower the car.

6. Connect exhaust hoses and start the engine. Check that the exhaust system does not leak.


PRE-RELEASE