(234-2745) Replacing the fuel pump
|
MODIFICATION INSTRUCTION
|
|
Bulletin Nbr:
|
234-2745
|
|
Date:
...........
|
April 2011
|
|
Market:
|
Se separat lista
|
|
Customer Satisfaction Campaign 154 63
|
Cars in stock must be rectified before delivery.
A personal communication must be sent to the owners of cars already delivered requesting them to get in touch with the nearest Saab garage as soon as possible to have the fault rectified.
Saab 9-3 (9440)
4WD
M10-11 with engine alternative L850 (4-cyl petrol) within the following Vehicle Identification Number range A1613284-B1306691
|
Note
|
|
Some vehicles within the Vehicle Identification Number range are not affected, see separate information for the Vehicle Identification Numbers affected.
|
Due to a manufacturing fault the service life of the fuel pump may be shortened considerably and this can lead to the engine not starting or stopping while driving.
12 781 173 Fuel pump
22 682 111 Seal
92 153 058 Pop rivet 4x12 mm
13 324 897 Screw kit, propeller shaft (3/car)
Thread locking adhesive, Loctite 242
For fitting the modification identity plate (not US/CA):
12 785 148 Modification identity plate
|
Checking the modification identity plate (not US/CA)
|
Before proceeding, check box A2 of the modification identity plate. From and including M04, the table "Table of Modifications" can be found in the car's Warranty and Service Book. A modification identity plate must be fitted in accordance with the section "Fitting the modification identity plate" where local directives require the marking of the car. If the box is not marked, continue as follows.
|
1.
|
Check the fuel level in the fuel tank. If there is more than 1/4 tank of fuel then the fuel tank must be drained, see WebWIS-9-3- (9440) - 2.Engine - 4-cyl petrol/E85 - Fuel system - Adjustment/Replacement - Draining the fuel tank, 4WD.
|
|
2.
|
Remove the complete exhaust system,
See WebWIS-9-3- (9440) - 2.Engine - 4-cyl petrol/E85 - Exhaust system - Adjustment/Replacement - Complete exhaust system, 4WD.
|
|
3.
|
Remove the fuel tank,
See WebWIS-9-3- (9440) - 2.Engine - 4-cyl petrol/E85 - Fuel system - Adjustment/Replacement - Fuel tank, B207 4WD.
|
|
4.
|
Change fuel pump, see WebWIS-9-3- (9440) - 2.Engine - 4-cyl petrol/E85 - Fuel system - Adjustment/Replacement - Fuel pump, 4WD.
|
|
6.
|
Fit the complete exhaust system.
|
|
Marking the modification identity plate (not US/CA)
|
After carrying out the procedure, box A2 on the modification identity plate must be marked. From and including M04 the table "Table of Modifications" can be found in the car's Warranty and Service Book. Mark the box with the number "7" if the procedure was carried out by the importer or with the number "8" if carried out by the dealer.
|
Fitting the modification identity plate (not US/CA)
|
|
Note
|
|
A modification identity plate must only be fitted where local directives require the marking of the car.
|
Fit the modification identity plate in accordance with WIS
9-3 (9440) M04 - General - General - Technical data - Plates and labels
|
Warranty/Time Information
|
See separate information.
