PRE-RELEASE
Pressure switch, engine oil (44), Z19DTR
Pressure switch, engine oil (44), Z19DTR |
To remove |
1. |
Disconnect the negative cable from the battery.
|
2. |
Raise the car.
|
3. |
CV: Remove
Chassis reinforcement, front subframe, CV, diesel
.
|
4. |
Remove the lower engine cover (A).
![]() |
5. |
Undo the cable clips (A) from the EHPS holder.
![]()
|
6. |
Unplug the pressure sensor connector (B).
![]() |
7. |
Remove the pressure sensor (C).
|
To fit |
1. |
Fit the pressure sensor.
Tightening torque 30 Nm (22 lbf ft)
![]() |
2. |
Plug in the pressure sensor connector (B).
![]() |
3. |
Fit the cable clips (A) to the EHPS holder.
|
4. |
Fit the lower engine cover (A).
![]() |
5. |
CV:
Chassis reinforcement, front subframe, CV, diesel
.
|
6. |
Lower the car.
|
7. |
Fit the battery negative cable.
|
8. |
Connect an exhaust extractor hose and start the engine to check everything runs correctly.
|
9. |
Check engine oil level, top up as necessary to the prescribed level.
|
10. |
Carry out
Procedures after reconnecting the battery
.
|