PRE-RELEASE
Front silencer, Z19DTR
| Front silencer, Z19DTR |
| To remove |
| 1. |
Raise the car.
|
|
| 2. |
Slacken the nut of the exhaust pipe clip.
|
|
| 3. |
Cut the exhaust pipe as per specified measurement, 130 mm. Use
83 95 667 Pipe cutter, exhaust system
.
Suspend the silencer using 83 95 212 Strap . |
|
| 4. |
Remove the front silencer. Cars with particle filter - pipe only.
|
|
| To fit |
| 1. |
Clean the joints and connecting pipe.
|
|
| 2. |
Fit the joint clamps.
|
|
| 3. |
Fit the front pipe with new rubber mountings.
|
|
| 4. |
If necessary also replace the rubber mountings of the rear silencers.
|
|
| 5. |
Adjust the joint clamps so that the pipe joints are in the middle of the joint clamps. The openings should face the rear.
|
|
| 6. |
Adjust the front and rear silencers so they hang evenly.
|
|
| 7. |
For cars with visible tailpipe, adjust this so that it hangs in the centre of the tailpipe cutout in the rear bumper.
|
|
| 8. |
Tighten the joint clamp nuts.
Tightening torque 40 Nm (30 lbf ft) |
|
| 9. |
Tighten the front exhaust pipe clamp.
Tightening torque 40 Nm (30 lbf ft) |
|
| 10. |
Lower the car.
|
|
| 11. |
Connect exhaust hoses and start the engine. Check that the exhaust system does not leak.
|
|
