PRE-RELEASE
Drive belt, auxiliaries
| Drive belt, auxiliaries |
| To remove |
| 1. |
Raise the car.
|
|
| 2. |
CV:
Remove
Chassis reinforcement, front subframe, CV
.
|
|
| 3. |
Fit
83 96 145 Centring fixture, subframe - engine
on the engine's subframe and
83 96 152 Centring tool, power train
with
32 025 059 Support
. First remove the two long supports. Relieve the load from the engine.
|
|
| 4. |
Remove the front spoiler shield.
|
|
| 5. |
Lower the car.
|
|
| 6. |
Remove the upper section of the air cleaner.
|
|
| 7. |
Remove the lower section of the air filter.
|
|
| 8. |
Remove the engine pad.
|
|
| 9. |
Remove the power steering pipe clip from the engine mounting.
|
|
| 10. |
Remove the engine mounting from the engine.
|
|||||||
| 11. |
Relieve the tension in the belt with a ½" handle and remove the belt. Guide the belt behind the belt tensioner's gear. Mark the direction of rotation if the belt is to be re-fitted.
|
|
| To fit |
| 1. |
Position the belt, relieve the load on the belt tensioner and fit the belt. Start by fitting the belt on the belt tensioner.
|
|
| 2. |
Check the belt position on all pulleys.
|
|
| 3. |
Fit the engine mounting to the engine (some models do not have a lower bolt).
Tightening torque 93 Nm (69 lbf ft) 
|
|
| 4. |
Fit the power steering pipe clip to the engine mounting.
|
|
| 5. |
Fit the engine pad.
Tightening torque to body: 50 Nm + 180° (37 lbf ft + 180°) Tightening torque to engine mounting: 45 Nm + 90° (33 lbf ft+ 90°) 
|
|
| 6. |
Fit the lower section of the air cleaner.
|
|
| 7. |
Fit the upper section of the air cleaner.
|
|
| 8. |
Raise the car.
|
|
| 9. |
Fit the front spoiler shield.
|
|
| 10. |
Remove Centring fixture, subframe and Centring tool, power train and Support.
|
|
| 11. |
CV:
Fit
Chassis reinforcement, front subframe, CV
.
|
|
| 12. |
Lower the car.
|
|
