Intermediate exhaust pipe, rear 4WD
|
|
Intermediate exhaust pipe, rear 4WD
|
|
3.
|
Remove the heat shield (A) from the exhaust manifold.
|
|
5.
|
Remove the intermediate exhaust pipe from the exhaust manifold (B) and turbocharger (C).
|
|
1.
|
Attach the intermediate exhaust pipe to the turbocharger and the front exhaust manifold. Use a new gasket and coat the studs with
90 513 210 Universal paste
. Fit all nuts.
|
Important
|
|
The conical side of the nut should face the centre exhaust pipe.
|
|
|
|
|
2.
|
Tighten the nuts as illustrated - first on the exhaust manifold (B) and then on the turbocharger.
Tightening order (B1, B2, B3) and (C) alternately on the turbocharger.
Tightening torque 30 Nm (22 lbf ft)
|
Important
|
|
The surfaces should align with one another when the nuts are fitted. Check using a feeler gauge. If the surfaces are not flat or the pipe is deformed, the centre exhaust pipe and/or exhaust manifold must be replaced.
|
|
|
|
|
4.
|
Fit the heat shield on the exhaust manifold. (A)
Tightening torque, bolts: 10 Nm (7 lbf ft)
|
