PRE-RELEASE
Master cylinder, RHD
| Master cylinder, RHD |
| To remove |
| 1. |
Apply wing covers.
|
|
| 2. |
Connect
88 19 096 Bleeding equipment
hose to the bleed nipple on the slave cylinder and draw out the brake fluid from the clutch system.
|
|
| 3. |
Remove the accumulator from the master cylinder and the hose from the brake fluid reservoir.
|
|
| 4. |
Remove the centre console right-hand front side panel.
|
|
| 5. |
Remove the data link connector and the lower dashboard panel.
|
|
| 6. |
Remove both main cylinder nuts.
|
|
| 7. |
Remove the pushrod from the clutch pedal. Use a pair of pliers with bent jaws.
|
|
| 8. |
Remove the master cylinder.
|
|
| To fit |
| 1. |
Transfer the hose to the new master cylinder.
|
|
| 2. |
Fit the master cylinder.
|
|
| 3. |
Press on the pushrod and tighten the nuts.
Tightening torque 20 Nm (15 lbf ft) |
|
| 4. |
Pull out the adjustment rod from the self-adjusting cruise control switch and press it back with the pedal for correct adjustment.
|
|
| 5. |
Fit the lower dashboard panel and the data link connector.
|
|
| 6. |
Fit the centre console right-hand front side panel.
|
|
| 7. |
Connect the hose from the brake fluid reservoir.
|
|
| 8. |
Fit the accumulator.
|
|
| 9. |
Bleed the clutch as described in
Bleeding the clutch hydraulic system in the car
.
|
|
| 10. |
Remove the wing covers.
|
|
| 11. |
Test the clutch operation.
|
|
