PRE-RELEASE
Brake disc, rear
| Brake disc, rear |
| To remove |
| 1. |
Raise the car.
|
|
| 2. |
Remove the wheel.
|
|
| 3. |
Remove the retaining spring from the brake caliper.
|
|
| 4. |
Remove the protective covers. Remove the hydraulic body and suspend it with a hook on the brake pipe holder.
|
||||||||||
| 5. |
Remove the brake pads.
|
|
| 6. |
Undo the screw of the upper suspension arm to provide access to the screw of the brake caliper retainer.
|
|||||||
| 7. |
Remove the brake caliper carrier.
|
|
| 8. |
Remove the brake disc locking bolt. Lift off the brake disc.
|
|
| To fit |
| 1. |
Clean all the contact surfaces between the hub and the brake disc.
Fit the brake disc and locking bolt. Tightening torque 7 Nm (5 lbf ft)
|
|
| 2. |
Clean the contact surfaces between the brake caliper carrier and the steering swivel member.
Fit the brake caliper carrier with 74 96 268 Thread locking adhesive . Tightening torque 130 Nm +45° (96 lbf ft +45°)
|
|
| 3. |
Screw in the brake piston using
89 96 969 Resetting tool
and
89 96 977 Adapter
.
|
|
| 4. |
Fit the brake pads.
|
|
| 5. |
Fit the hydraulic body to the holder.
Tightening torque 28 Nm (21 lbf ft) Fit the protective covers. 
|
|
| 6. |
Fit the retaining spring to the brake caliper.
|
|
| 7. |
Tighten the suspension arm screw.
Tightening torque: 125 Nm +135° (92 lbf ft +135°) |
|
| 8. |
Fit the wheel
.
|
|
| 9. |
Lower the car.
|
|
| 10. |
Press the brake pedal a few times to press out the brake pistons and the handbrake adjustment.
|
|
